- #Sony firmware update usb mac os x#
- #Sony firmware update usb upgrade#
When performing the firmware update, it's recommended to use a fully charged NP-FV70 rechargeable battery pack or AC adapter.
#Sony firmware update usb mac os x#
If the update still fails, format the USB flash drive to FAT32 and try again. Mac OS X version 10.9 - 10.11 Camera power supply: This update can only be performed when the remaining battery level has three bars or more. If the update does fail, delete other files and try again with only the update file saved in the USB flash drive. The update can fail even when using a USB flash drive that meets the above conditions, depending on the size and directory structure of other files on the drive.
#Sony firmware update usb upgrade#
If the firmware version shown is 3.1.2, the upgrade was successful.
The update file must be saved in the root directory of the drive After the update, confirm that the new version has been installed successfully by following the steps in the Check the firmware version section. The drive will need to have sufficient free space to accommodate the update file. The drive must be formatted in FAT16, FAT32, exFAT or NTFS. The USB flash drive must meet the following conditions: The software update will start automatically. Connect the USB flash drive (with the software update) back into the USB port on the TV. The USB memory may not contain the correct update file. If the message 'Please visit the support site and connect the USB device (with Update firmware) to USB port' is displayed on the unit, check the files in the USB memory. Unplug the TV’s power cord while the TV screen is on. The update file may not be saved in the correct location in the USB memory, or the file type may not be supported. When removing external HDDs or USB flash drives, check that their access LEDs have stopped blinking first. Remove the USB device(s) connected to the TV. A status indicator is shown on your computer screen. Depending on the type of firmware update, the update process may take up to 10 minutes or longer. IMPORTANT: Do not power off the camera or disconnect the USB cable until the update process is complete. If the illumination LED or Status LED is not blinking white: Go to step 2. Follow the directions on your computer’s screen to start the firmware update. Please wait until the update is complete. If the illumination LED or Status LED is blinking white: The software (firmware) update has started. Check the status of the illumination LED/Status LED on the TV.
0 kommentar(er)
